Serial
ATA (SATA) PHY
Transceiver IP [Compliant with Serial Attached SCSI (SAS)]
SMS6000 Serial ATA (SATA) Transceiver PHY IP
which is
compliant with Serial Attached SCSI (SAS) supports following features:
- Supports 1.5 Gb/s (Gen 1) and 3.0 Gb/s (Gen 2) serial data rate
- Compatible with Serial ATA II
- Utilizes 10-bit or 20-bit parallel interface to transmit and receive Serial ATA
data
- Data and clock recovery from serial stream on the SATA bus
- Optional 8b/10b encode/decode and error indication
- Near-End and Far-End Loop-back Support
- Embedded Bit Error Rate Testing Through PBRS generation and detection
- Supports HOST and DEVICE controller applications
- OOB Signal Detection for COMWAKE, COMRESET/COMINIT and COMSAS
- COMMA & Squelch Detect Support
- Power Management Support for Slumber and Partial PM Modes.
- Calibrated Internal RX, TX Termination Resistors
- Support for Serial Attached SCSI SAS Mode
- Compliant with SATA PHY Interface Specification (SAPIS)
- Full low cost, low power CMOS Implementation
SMS6000
Serial ATA (SATA) & Serial Attached SCSI (SAS) PHY Transceiver Data Sheet
Soft
Mixed Signal Corporation is a Serial ATA Organization Member

|